pdf mechanical properties of alsi10mg produced by

High-temperature mechanical properties of AlSi10Mg

Abstract Mechanical properties (tensile strength and creep) of AlSi10Mg specimens fabricated by selective laser melting (SLM) in the Z-direction were investigated in the 25-400 °C temperature range. Specimens were tested after stress relief treatment. The results revealed that yield stress (YS) significantly decreases and the elongation increases at temperatures higher than 200 °C. Mechanical properties of AlSi10Mg lattice structures Jul 01, 2020 · Table 5 is the morphological parameters of lattice structures and mechanical properties of cellular AlSi10Mg samples. The increase of the compressive elastic modulus means that the lattice structures with a large diameter and an optimized radius tends to withstand a large pressure and a better mechanical response when the same level of deformation occurs.

Microstructure of selective laser melted AlSi10Mg alloy

Apr 15, 2019 · Among Al-based alloys, AlSi10Mg alloy is a traditional cast alloy and highly demanded for many applications in aerospace and automotive because of its light weight, low thermal expansion and good mechanical properties [16,17]. AlSi10Mg alloy has good weldability because of the near eutectic composition of Al and Si. PFC:AlSi10Mg parts produced by Selective Laser Melting SLM produced parts is given. 2.1. Properties AlSi10Mg is a widely used alloy, characterized by its high corrosion resistance and low density, compared with other alloys. It has good weldability, good castability, hardenability and good static and dynamic resistance. The thermal conductivity is very high. PROCESS OPTIMIZATION AND MICROSTRUCTURAL Aug 17, 2011 · MELTING OF AlSi10Mg . K. Kempen*, L. Thijs , E. Yasa*, M. Badrossamay*, W. Verheecke° and J.-P. Kruth* matrix without compromising the other mechanical properties to a significant extent. Table 1.Chemical composition of AlSi10Mg [4] Alloying element produced. The high intensity laser beam makes it possible to completely melt and

Structure and Mechanical Properties of AlSi10Mg Fabricated

Additive manufacturing (AM) of metals is a relatively novel fabrication approach with growing interests in many industries. The AM process is based on building products originating from 3-D computer models, through localized melting of powder in a layered structure. The present research focused on the metallurgical investigation of AM AlSi10Mg parts fabricated by SLM-AM.Mechanical Properties of AlSi10Mg Produced by Selective Jan 01, 2012 · Abstract. Selective Laser Melting (SLM) is an Additive Manufacturing (AM) technique in which a part is built up in a layer- by-layer manner by melting the top surface layer of a powder bed with a high intensity laser according to sliced 3D CAD data. In this work, mechanical properties like tensile strength, elongation, Young's modulus, impact toughness and hardness are investigated for SLM-produced AlSi10Mg parts, and compared to conventionally cast AlSi10Mg